Shop by Category
Art Stamp Mounting & Indexing
Brother Stampcreator PRO
Brother Tapecreator PRO
Daters & Numbering Machines
Die Plate Band Stamps
Diemaking Services - Rubber/Polymer
Gift Certificate
Hand Stamp Mounts & Handles
Hot Foil Stamping
IDEAL/Trodat Self-Inking Stamps
IDEAL/Trodat Self-Inking Daters & Numberers
PROFESSIONAL Self-Inking Stamps
Inks & Cleaners
Laser & Rotary Engraved Stamps
Negative Production Supplies
Photopolymer Equipment
Photopolymer Supplies
Pocket & Special Mounts
Production MACHINES!
Promotional Support Products
Ribbon Printer
Rubber Molding Supplies
Seals & Embossers
Shipping Supplies
Stamp Pads
Stamp Storage Devices
Vulcanizer Accessories
Vulcanizers
|
Laser Engravable Rubber - Extra Thick
|
|
Item Number: LR-ET
Quantity Discounts - Order a quantity of this item to receive the lower price
| Quantity | Amount |
| 2 to 4 | $21.36 |
| 5 to 24 | $20.16 |
| 25 to 49 | $18.72 |
| 50 to 99 | $16.80 |
| 100 to 1000 | $15.36 |
|
|
This gray pre-vulcanized Laser Rubber is approximately .120” or 1/8” thick. A4 sheet size (about 8¼” x 11¾”). Clean burning leaving a white ash residue. In production it has an odor that may be offensive to some people. Must be washed with detergent and water after engraving. Confirm that your laser equipment is suitable for engraving stamp dies. Check with your laser equipment manufacturer to determine compatability of equipment and software.
The settings below are a good starting point as you begin test engraving this material. Use your laser’s software settings for “stamp” mode or “3D effects” mode. Adjust speed and power settings as needed. Use your machine’s air assist mode while engraving. Observe the following precautions: • Laser engraving or cutting rubber can possibly ignite the material. Never leave the laser system running unattended for any reason.
• Laser engraving or cutting rubber can produce foul odors. You may need to particulate filter or odor filter your exhaust depending on your environment, installation location and local air quality control regulations.
• Laser engraving or cutting rubber can produce abrasive dust and smoke. You will need to clean your laser more frequently to reduce wear and tear and keep the optics clear.
• Laser Rubber can be engraved on either side.
• When vector cutting this material be sure to use a vented cutting table. Without a cutting table the likelihood of flame increases.
• After engraving, wash the material with detergent and water. Then rinse and towel dry.
|
Use your laser to cut perfect stencils!
|
Attach Your Stamp Die to any Metal Surface
|
Thick tape with sticky natural rubber provides excellent adhesion.
| |
|
|